Dec 23, 2019 · I have been trying to simulate a VCO for a CB radio on LTspice, but cannot get it to run. The ac analysis give me a peak at about 3.5 MHz but cannot get anything from the .trans. It is …

Feb 15, 2013 · Hi, I wrote UART code that sends UART data to the PC. I want to simulate it and therefore need to see a terminal that will present the data being sent to the PC from the PIC during …

Nov 9, 2018 · I'm attaching an LTspice file that simulates a crystal oscillator with resonant frequency 1MHz, and it works fine. But if I change L1 from 2.5 H to 9.8 mH to simulate a crystal oscillator with …

Apr 19, 2025 · Hi everyone! We’re opening this special thread dedicated to sharing fully simulatable examples using the OshonSoft IDE, perfect for those who program in PIC Basic as well as for those …

Mar 27, 2015 · Hello I tried to simulate a NTC thermistor with Orcad Pspice lit. following some models found on the web, I replaced the NTC by a VCCS with gain depending on TEMP. Netlist is joined but …

Oct 19, 2011 · How to simulate complex (non-library) components anso-engineer Jan 31, 2025 Circuit Simulation & PCB Design Replies 4 Views 5K Feb 1, 2025

Dec 23, 2015 · Hello I make a simple simulation of a dc current source applied on a 10 Kohms thermistor. When I perform a transient simulation (I1 = 10 mA until 10 s) , the thermistor warms up …

Dec 9, 2020 · I want to simulate the below tone control circuit values to get good perfomance.But in LT spice I get some wiered curves.Am I doing it wrong..??

Jul 26, 2016 · In connection with this other thread, I developed LTspice simulation models respectively for single and dual-coil DPDT latching relays, based on data from...

Dec 31, 2022 · Does anybody know how to simulate high frequency signal and circuit in proteus? For several hundreds KHz it works well but when signal are in MHz range the circuit does not work. I …